Due to COVID-19, you might see a delay in transit time. We will contact you if your order is delayed. Currently, Expedited Shipments Are Not Guaranteed By Carrier.

STRUT MASTERCRAFT 1986 UP 1-1/8 INCH DRIVE SHAFT - INCLUDES NEW BEARINGS

$448.95 $606.86

Has 8 Mounting holes and includes brass shelled rubber strut bearings! Fits 1986 up Mastercraft boats with the Powerslot or V-drive 1-1/8" shafts with an 8 bolt mounting pattern. 16...

Has 8 Mounting holes and includes brass shelled rubber strut bearings!

Fits 1986 up Mastercraft boats with the Powerslot or V-drive 1-1/8" shafts with an 8 bolt mounting pattern. 16 Degree.

Fits all 2003 and up with a splined shaft.

This is a Marine Hardware strut and will not have Mastercraft on the side.

Marine Hardware struts are precision bored to meet ABYC and Navy standards for
light press fit of brass-shelled rubber bearings.

These interchangeable bearings are installed with stainless steel cup point set screws for a firm mechanical lock. The length of the strut barrel (and bearing) is at least four times the diameter of the prop shaft.

The thickness of the strut barrel is equal to at least one-fourth the diameter of the prop shaft. The average thickness of the leg(s) is determined by mathematical  formula prescribed by the ABYC.


ABYC and Navy standards require backing plates or backing washers
with four-bolt mounting, but not with six-bolt mounting, for shaft
diameters up to four inches.

We take special pride in precision machining bases of all struts so
the parts are interchangeable from boat to boat, and specified shaft
angles are maintained.