Due to COVID-19, you might see a delay in transit time. We will contact you if your order is delayed. Currently, Expedited Shipments Are Not Guaranteed By Carrier.

STRUT - 15 DEGREE - 1-1/8 INCH SHAFT 6 HOLE BOLT PATTERN STSL-15 INCLUDES STRUT BEARINGS

$497.49 $616.99

Fits boats with 1-1/8" driveshaft and 6 bolt mounting pattern15 degree. Has 6 Mounting Holes and includes brass shelled rubber strut bushings! All struts are precision bored to meet ABYC...

Fits boats with 1-1/8" driveshaft and 6 bolt mounting pattern
15 degree.

Has 6 Mounting Holes and includes brass shelled rubber strut bushings!

All struts are precision bored to meet ABYC and Navy standards for light press fit of brass-shelled rubber bearings. These interchangeable bearings are installed with stainless steel cup point set screws for a firm mechanical lock.

The length of the strut barrel (and bearing) is at least four times the
diameter of the prop shaft. The thickness of the strut barrel is equal to at least one-fourth the diameter of the prop shaft. The average thickness of the leg(s) is determined by mathematical formula prescribed by the ABYC.

ABYC and Navy standards require backing plates or backing washers
with four-bolt mounting, but not with six-bolt mounting, for shaft
diameters up to four inches.

We take special pride in precision machining bases of all struts so
the parts are interchangeable from boat to boat, and specified shaft
angles are maintained.