Ignition Kit Mallory Pertronix Ignitor II For Mallory Distributors PNX-9ML-181
Pertronix "Ignitor II" Electronic Ignition Conversion Kit
- Pertronix Ignitor II electronic conversion kit for Mallory 8 cylinder distributors
- Note that the cap has clips that pivot with screws at the top
- Pertronix recommends using the "Flame Thrower II" Coil Item# 45011 with this kit
- Eliminates the need of external resistance.
- Will NOT fit Mallory Magnetic Breakerless or E-Spark distributors!
- Compatible with 12 V negative ground systems and any induction coil
- High-rpm performance is improved when used with the PerTronix Flame-Thrower II super low- resistance (0.6 ohms) 45,000 V coil
- Adaptive dwell maintains peak energy throughout the entire rpm range, reducing misfires while improving engine performance
- Develops, on average, two times more available plug voltage
- Peak current level is reached just prior to spark for maximum energy without heat build-up, increasing coil and module life
- Never change points again!
- Adjusts spark timing at higher rpm to compensate for the inherent electronic delay
- Senses startup and develops more energy for quicker, easier starting
- Built-in reverse polarity and over current protection shuts down the system, preventing component damage
Cannot be used with solid core spark plug wires—suppression-style or spiral-wound spark plug wires must be used
Carb E0 Number: D-57-22
To see a list of qualifying vehicles, enter CARB E0 Number D-57-22