Pertronix "Ignitor II" Electronic Ignition Conversion Kit

PNX-9ML-181

• Pertronix Ignitor II electronic conversion kit for Mallory 8 cylinder distributors
• Note that the cap has clips that pivot with screws at the top
• Pertronix recommends using the "Flame Thrower II" Coil Item# 45011 with this kit
• Eliminates the need of external resistance.
• Will NOT fit Mallory Magnetic Breakerless or E-Spark distributors!

Features include:

• Compatible with 12 V negative ground systems and any induction coil
• High-rpm performance is improved when used with the PerTronix Flame-Thrower II super low- resistance (0.6 ohms) 45,000 V coil
• Adaptive dwell maintains peak energy throughout the entire rpm range, reducing misfires while improving engine performance
• Develops, on average, two times more available plug voltage
• Peak current level is reached just prior to spark for maximum energy without heat build-up, increasing coil and module life
• Never change points again!
• Adjusts spark timing at higher rpm to compensate for the inherent electronic delay
• Senses startup and develops more energy for quicker, easier starting
• Built-in reverse polarity and over current protection shuts down the system, preventing component damage

Cannot be used with solid core spark plug wires—suppression-style or spiral-wound spark plug wires must be used

Instructions PDF Link: HERE

Carb E0 Number: D-57-22

To see a list of qualifying vehicles, enter CARB E0 Number D-57-22

WARNING- This product can expose you to chemicals which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65warnings.ca.gov