Pertronix "Ignitor II" Electronic Ignition Conversion Kit 9-1581
Only 2 Left of this Old Style Kit as of 02/22/2021
- Then Pertronix went to the new style part 9-1581LS that fits both the Clip Down and Screw Down types.
- Prestolite V8 Clip Cap Electronic Ignition Kit
- Ignitor module replaces the points in Prestolite V8
- Clip down cap distributors - clips with screws at the base
- Fits inside the distributor for a stock look
- Kit includes module and new rotor
For the Prestolite clip down cap distributor through 1986
Pertronix recommends using the "Flame Thrower II" Coil; Item# 45011 with this kit & Eliminates the need of external resistance.
Features include:
- Compatible with 12 V negative ground systems and any induction coil
- High-rpm performance is improved when used with the PerTronix Flame-Thrower II super low- resistance (0.6 ohms) 45,000 V coil
- Adaptive dwell maintains peak energy throughout the entire rpm range, reducing misfires while improving engine performance
- Develops, on average, two times more available plug voltage
- Peak current level is reached just prior to spark for maximum energy without heat build-up, increasing coil and module life
- Never change points again
- Adjusts spark timing at higher rpm to compensate for the inherent electronic delay
- Senses startup and develops more energy for quicker, easier starting
- Built-in reverse polarity and over current protection shuts down the system, preventing component damage
- Cannot be used with solid core spark plug wires—suppression-style or spiral-wound spark plug wires must be used
- California EO Approved
Carb E0 Number: D-57-22
To see a list of qualifying vehicles, enter CARB E0 Number D-57-22